Features; Control Panel; Charging The Internal Battery - DieHard DH110 Manual Del Usuario

5. FEATURES

5
4
3
2
1

6. CONTROL PANEL

DIGITAL DISPLAY
NOTE: To change the language of
the scrolling display messages
to Spanish, press and hold the
button for 10 seconds.
When the clamps are connected to
a vehicle's battery, the digital display
indicates the battery's voltage. When not
connected to a battery, the digital display
is used to indicate the percent of charge
of the jump starter's internal battery. See
Display Messages for a complete list of
messages.
NOTE: If the vehicle's battery voltage is
too low to detect, the display will remain
blank; the voltage will not display. A manual
start procedure is required to enable
the jump start function. See Section 8.2,
Starting a Battery with Low Voltage.

7. CHARGING THE INTERNAL BATTERY

IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH
USE AND EVERY 3-6 MONTHS,
TO KEEP THE INTERNAL BATTERY
FULLY CHARGED AND PROLONG
BATTERY LIFE.
7.1 To reduce the risk of electric shock,
unplug the unit's wall charger from the
outlet before attempting any maintenance
or cleaning. Simply turning off the controls
will not reduce this risk.
6 7
10
13
12
11
1. Case
2. Battery clamps
8
3. Jump Starter/12V Power Pack
4. 12V/USB button
5. Light button
9
6. Charging LED indicator
7. Digital display
8. 12V DC device car charger
9. 100V~120V AC wall charger
10. Jump Start button
11. Jump starter input socket
12. 12V DC port
13. USB port
15
14
14. Light
15. 12V Input socket for recharging
NOTE: During charging, the display will
go into sleep mode and will not display
any messages. To turn the display back
on, press any button.
LED INDICATOR
• Green LED solid – The internal battery
is charging.
• Green LED flashing – Charging has
aborted.
• Green LED pulsing – The internal
battery is fully charged.
FUNCTION BUTTONS
7.2 When charging the internal battery, work
in a well ventilated area and do not restrict
the ventilation in any way.
7.3 CHECKING THE LEVEL OF THE
INTERNAL BATTERY
To check the internal battery's charge
level, make sure the unit is turned OFF,
then press the
display will show the battery's percent of
charge. A fully charged internal battery will
read 100%. Charge the internal battery if
the display shows it is under 100%.
• 6 •
LIGHT – Operates the LED light
12V/USB – Enables the 12V DC
port and the USB port
JUMP START – Enables the jump
start function
or button. The digital