Using The Remote Control - Hisense 5K BTU DOE Instrucciones De Instalacion Y Uso

Timer Sleep Filt r e
1. The LED light on
control panel
Ti Timer Sleep Filter
2. The function introduction see "using the remote control".
NOTE: Remote control may differ in appearance.
wing
wing
NOTE:
Press and hold the MODE button on the remote for 5 seconds to
switch the temperature display from degrees Fahrenheit (°F)
to degrees Celsius (°C). Quiet mode is only valid in cooling
mode. It takes about 2 to 3 minutes to fully enter quiet mode.
Sometimes it cannot enter the quiet mode because of some
protection.
for Timer、Sleep、Filter.

Using the Remote Control

FILTER
1
FILTER
FILTER
1
WIFI
WIFI control is available for connected models with this
logo on control panel.
1. Press the CONNECT button for 5s,the LED starts to flash.
2. After the WIFI module connecting the router,the LED
keeps on.Or the LED keeps off.
NOTE: WIFI control is available only for WIFI control models.
To turn off Super control, press any button on the remote control or control panel
except Timer On, Timer Off, Clock, Dimmer and Swing.
10
CONNECT