Digital Display - Teka LI5 1080 Manual Del Usuario

SPIN SPEED button
l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
l
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
l
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
l
It is possible to modify the spin speed
without pausing the machine.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
KEY LOCK
l
Pressing simultaneously
TEMPERATURE SELECTION and SPIN
SPEED for about
machine allows you to lock the keys. In
this way, you
accidental or unwanted changes if a
button on the
accidently during a cycle.
foaming. If the
the load be
the buttons
3 seconds, the
can avoid making
display is pressed
42
l
The key lock can be simply cancelled by
pressing the two buttons simultaneously
again or turning off the appliance.

Digital Display

The display's indicator system allows you to
be constantly informed about the status of
the machine.
1 2
1) OPTIONS INDICATOR LIGHTS
The indicator lights show the options that
can be selected by the relevant button.
2) CYCLE DURATION
l
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
l
During the initial filling phase of the cycle
the machine calculates the actual cycle
time needed based on the load size,
content and options selected. The real
time of the wash will then be displayed.
This time can recaulculate during the
wash depending on detergent levels and
load balancing.
3) DOOR LOCKED INDICATOR LIGHT
l
The indicator light is illuminated when the
door is fully closed.
Close the door BEFORE selecting the
START/PAUSE button.
3 4 5 6 7