Rupes TA531A Instrucciones De Uso Y Manutención página 10

MOUNTING THE BACKING PAD (TA531A - TA551A)
1. Press the lock button (11);
2. screw the backing pad on by hand while keeping the release
button pressed (9);
3. reverse the procedure when removing the backing pad.
REMOVING AND MOUNTING THE DISC PAD (TA562A)
- Unscrew the screws on the disc pad;
- reverse the procedure when fitting the disc pad.
FITTING ABRASIVE PAPER DISCS
Press the abrasive disc into the pad ensuring that the holes in the
paper coincide with extraction holes in the disc pad.
BEFORE STARTING THE TOOL
Ensure that:
- the compressed air feed line and connection are in perfect
working order;
- the start switch (2) is working properly. This must be done with
the air supply switched off;
- all the components of the tool are mounted correctly and do not
show any signs of damage.
STARTING AND STOPPING
- Starting: rotate knob (2) in the direction indicated by the arrow.
- Stopping: release the knob.
TEST RUN
Start the tool and check that there are no unusual vibration, no di-
smatching of the abrasive paper disc.
Otherwise switch-off the tool immediately and eliminate the
cause.
10
SELECTING THE RPM
The rpm can be adjusted by rotating the knob (3). The choice of
speed depends on the characteristics of the abrasive paper disc
and the material to be worked.
SUCTION FLOW CONTROL
The suction flow can be adjusted by rotating ring-nut (6).
REPLACING THE ABRASIVE PAPER DISCS
- Used discs can be removed by simply tearing them off;
- new velcro discs are mounted by simply pressing them into the
backing pad, making sure that the holes cut in the disc coincide
with those in the backing pad.
USABLE DISCS
TA531A - TA551A
Ø mm 150 velcro backed abrasive paper discs with dust extraction
holes.
TA562A
Ø 200 mm velcro backed abrasive paper discs with dust extraction
holes.
MAINTENANCE
All maintenance operations are carried out with the tool discon-
nected from the compressed air supply.
At the end of each work session, or when required, remove any
dust from the body of the tool using a jet of compressed air.
Lubricate the machine regularly (every 50 hours of operation)
by inserting 2/3 drops of specific oil into the compressed air
connection, keeping the device in a vertical position, with the
connection facing upwards. After this operation, connect the
machine to the power supply and set it in motion for a few
seconds.Lubricate the machine as described above before
storing it for long periods of inactivity.All damages deriving
from incorrect or inadequate lubrication are excluded from the
warranty.