Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (G) and lay it over your unit.
Make equal margins along all four edges of the BACK (G).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (G) to your unit using the NAILS (14).
å
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Perforation
Page 14
This perforation
should be cut out
for the USB cord.
G
www.sauder.com
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(34 used in this step)
Perforation
14
420494
Publicidad
