Sime RS MK II Serie Manual Del Usuario página 50

2.7 ASSEMBLING THE FLUE
GAS CHAMBER
The.flue.gas.chamber.is.supplied.in.four.pie-
ces.to.be.joined.with.screws.supplied.(fig..7)..
It.is.assembled.by.anchoring.the.right.side.pa-
nel.(2)..to.the.upper.panel.(1)..with.nine.self-
tapping.TE.12E.x.1/2".screws..
The. same. operation. must. be. performed.
on. the. left. side. panel. (3).. Lastly,. anchor. the.
cleaning. panel. in. place. (4).. When. assembly.
is. complete,. position. the. flue. gas. chamber.
above.the..cast.iron.body..Anchor.the.flue.gas.
KEY
1.. Upper.panel
2.. Right.side.panel
3. Left.side.panel
4.. Cleaning.panel.
50
KEY
1.. Plug
2. Flange.ø.35/87
3.. Two-way.cone
4.. Tie.rod.L..900.+.tie.rod.L..980
5.. Flange.ø.50/87
6.. Pipe.segment.
7.. Thrust.bearing
8.. Nut
9.. Tightening.key
chamber.to.the.body.using.the.four.plates.and.
the.four.TE..M8.x.30.screws.supplied.(fig..7/a).
2.8 ASSEMBLING THE WATER
DISTRIBUTOR
The. water. distributor. on. the. return. line. co-
ming. in. from. the. heating. system. is. located.
on.the.right.side.of.the.generator..If.it.is.ne-
cessary.to.move.it.to.the.left.side,.check.that.
the. two. rows. of. holes. in. the. distributor. are.
directed.upwards.and.toward.the.front.of.the.
KEY
1.. TE.M8.x.30.screw
2.. Plate
3.. Washer.ø.8,4
4.. Nut.M8
boiler.(fig..8).
Fig..6
KEY
1.. Boiler.body.
2.. M12.x.60.stud.bolt
3.. Seal.ø.65/95.x.2
4.. Distributor.pipe
5.. DN50.2".collar.flange
6.. Nut.M12
2.9 ASSEMBLING THE BURNER
MANIFOLD
To. assemble. the. burner. manifold,. screw. in.
the.four.TE.M8.x.16.screws.on.the.threaded.
nibs.of.the.two.heads.of.the.boiler.body.(fig..9).
Fig..7
KEY
1.. Burner.manifold
2.. TE.M8.x.16.screws
3.. Right.head
2.10 ASSEMBLING THE BURNERS
Once. the. burner. manifold. has. been. assem-
bled,. insert. the. burners. in. the. combustion.
chamber.one.at.a.time,.ensuring.that.the.slits.
in.the.burner.are.turned.upward..
Push. so. that. the. burner. support. goes. into.
the.hole.in.the.cast.iron.wall.and.divides.the.
Fig..7/a
elements. (fig.. 10).. Anchor. the. burner. to. the.
manifold.with.a.TCB.M5.x.8.screw.
Fig..8
Fig..9