Silvercrest SSJ 150 A1 Instrucciones De Uso página 47

Licuadora de extracción lenta
Ocultar thumbs Ver también para SSJ 150 A1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 145
TIP
Soak carrots in water for around 24 hours before juicing.
Cut the carrots into small pieces (approx. 2 x 2 cm).
During juicing, press only lightly with the pusher
ance can block.
NOTE
If fruit/vegetable pieces get stuck in the feed tube
with the pusher
SAFETY CUT-OUT / RESET FUNCTION
If fruit pieces get stuck and the appliance turns itself off automatically, this
means that the safety cut-out has tripped. The appliance switches itself off
before the motor can be damaged by overheating. The appliance cannot
be switched back on until you reset the safety cut-out.
Proceed as follows to be able to use the appliance again.
SSJ 150 A1
, proceed as follows:
Switch off the appliance immediately and pull the plug on the power
cable
out of the socket.
Turn the housing lid
towards the marking on the sieve tray holder
into place.
Remove the housing lid
Remove the fruit or vegetable pieces causing the blockage.
Reassemble the appliance and continue with juice extraction.
Set the on/off switch
power cable
out of the socket. Allow the appliance to cool down
for 10–15 minutes.
Turn the housing lid
towards the marking on the sieve tray holder
into place.
Remove the housing lid
Remove the fruit or vegetable pieces causing the blockage.
Carefully remove the sieve tray
base
over.
Press the "reset" button on the underside of the appliance base
Reassemble the appliance and continue with juice extraction.
anticlockwise until the
.
into the "O" position and pull the plug on the
anticlockwise until the
.
and turn the appliance
, otherwise the appli-
and cannot be freed
marking points
and clicks firmly
marking points
and clicks firmly
.
GB │ IE
 43

Publicidad

Tabla de contenido
loading

Tabla de contenido