Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
CAUSES
No froth is
•
generated.
•
•
No steam is
•
generated.
•
•
•
Coffee comes out
•
too quickly.
•
Coffee is too weak.
•
•
•
Steamed water
•
is coming out the
frothing dispensing
tube before the
frothed milk.
Frother body needs
cleaning.
Frother body is not installed
correctly.
Ran out of steam.
Water reservoir is empty.
Appliance is not turned on.
Frothing tube is blocked.
Brew/Steam Selector
Switch not on "
" mode.
Ground coffee is too
coarse.
Not enough coffee in filter.
Using small filter for two
demitasses.
Too much water is used.
Ground coffee is too
coarse.
Steam is being generated
in the unit before frothing
the milk.
En g lish -14
SOLUTIONS
•
Add water to water reservoir.
•
Ensure frother body is properly
installed.
•
Clean the frother body.
•
Clean until blockage is clear
plus an additional 20 seconds.
•
Fill reservoir with correct
amount of water and follow
steps to prime the unit.
•
Turn on unit and follow the
operating instructions.
•
Ensure frother body is properly
installed by pressing up until
you hear click.
•
Turn off unit, allow unit to cool,
unplug unit and clean out
frother body.
•
Ensure Brew/Steam Selector
Switch is on "
" mode.
•
Use a finer grind.
•
Use more coffee.
•
For additional guidance on
espresso and milk timing tips
consult the manual sections:
HOW TO BREW ESPRESSO &
RECIPES.
•
Use large filter for two
demitasses.
•
Manually stop the brew earlier
by turning the control knob
clockwise to the off position.
•
Use a finer grind.
•
While milk is being pulled
from milk reservoir into
frothing body, it is normal
to have steam and some
drops of water come out from
the adjustable frothed milk
dispensing tube for a few
seconds.
Publicidad
Tabla de contenido
