Troubleshooting And Maintenance - Jocel JCV-380LNFI Manual De Instrucciones

Ocultar thumbs Ver también para JCV-380LNFI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING AND MAINTENANCE

Trouble Shooting
Power cut
If the internal temperature of the Fridge/Freezer compartment is -18℃ or less when the
power returns, your food is safe. The food in your Fridge/Freezer will remain frozen for
approx 16 hours with the door closed. Do not open the Fridge/Freezer door more than
necessary.
The Fridge/Freezer is exceptionally cold
You may have accidentally
The Fridge/Freezer is exceptionally warm
The compressor may not be working.
and wait a few minutes. If there is no humming noise, it is not working. Contact the local
store where your purchase was made.
The Fridge/Freezer is not working
Check it is plugged in and switched on. Check that the fuse in the plug has not blown. Plug
In another appliance, such as a lamp, to see if the socket is working. The Fridge/Freezer
should be placed in a well ventilated room with an ambient temperature of between
and
43℃. Leave the Fridge/Freezer for 30 minutes.
Condensation appears on the outside of the Fridge/Freezer
This may be due to a change in the room temperature. Wipe off any residue of moisture. If
the problem continues contact the local store where your purchase was made.
GURGLING, WHOOSHING
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It
has become more pronounced since the introduction of CFC free gases. This is not a fault
and will not affect the performance of your Fridge/Freezer.
HUMMING, PURRING OR PULSATING
This is the compressor motor working, as it pumps the refrigerant around the system.
Moving the Fridge/Freezer
Location
Do not place your Fridge/Freezer near a heat source, eg. Cooker, boiler or radiator. Also
avoid direct sunlight in out-buildings or sun lounges.
Leveling the Fridge/Freezer
Make sure the Fridge/Freezer is level. Use the rotating leveling feet at the front. If the
Fridge/Freezer is not level, the doors and magnetic seal alignments will be affected and
may cause your Fridge/Freezer to work incorrectly.
set the refrigerator temperature
Set the refrigerator temperature
-43-
to a higher position.
to minimum setting
10℃

Publicidad

Tabla de contenido
loading

Tabla de contenido