Steam Cleaning - Steamfast SF-375 Guia Del Propietario

STEAM CLEANING

NOTE: Be sure that Boiler has been filled and that all desired accessories are connected
before following these steps.
1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into
a convenient electrical outlet.
2. Switch Lighted On/Off Switch to "I" (on) position. Heating Indicator Light will immediately
illuminate, indicating that unit is heating.
3. After approximately 10 minutes (depending on how much water is in Boiler), Heating Indicator
Light will turn off, indicating that unit is fully heated and ready to begin steaming.
4. Direct Steam Nozzle (and any connected accessories) towards surface you wish to steam, and
press Steam Trigger.
CAUTION: Always be sure that Steam Nozzle and any accessories are pointed in a safe
direction (away from yourself, other people, pets, and plants) before pressing
Steam Trigger.
5. Hold Steam Trigger down for a continuous flow of steam. You may also slide the Steam Lock
Switch forward while pressing the Steam Trigger to lock it down. This will allow a continuous
flow of steam without need of holding the Steam Trigger down manually.
6. Using a slight back-and-forth motion over the area you are steaming will further enhance the
cleaning process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime.
Wiping the area while it is still wet is recommended, but use caution when wiping surfaces such as
metal that may still be hot.
NOTE: During use, the Heating Indicator Light may illuminate. This is normal. If you
notice a drop in steam pressure, release Steam Trigger until Heating Indicator Light turns
off again.
7. To effectively kill bacteria and other microorganisms, hold Steam Nozzle (and any connected
accessories) approximately 1/2 inch from surface and press Steam Trigger. Keep Steam
Trigger held and concentrate steam on the same spot for at least 5 seconds.
8. Once steaming tasks are complete, immediately set Lighted On/Off Switch to "O" (off)
position and unplug grounded power cord from electrical outlet. Follow steps under Proper
Storage procedure on Page 15 of this manual.
All manuals and user guides at all-guides.com
ENGLISH | 13