Steam Cleaning - Steamfast SF-210 Guia Del Propietario

STEAM CLEANING

NOTE: Before operating, make sure all desired accessories are connected and Boiler is
filled with the correct amount of water (refer to Pages 6-9 for details).
1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug
power cord into a convenient 3-prong electrical outlet. Heating Indicator Light will illuminate to
show that unit is receiving power and Boiler has begun to heat.
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly
installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this
safety feature in any way.
2. After approximately 3 minutes, Heating Indicator Light will turn off. This indicates that Boiler is
fully heated, and unit is ready to begin steaming.
NOTE: Heating Indicator Light may cycle off and on during use, accompanied by a slight
temporary drop in steam pressure – this is a normal part of operation, as the Boiler
works to maintain a steady optimal temperature.
3. Point Jet Nozzle (and any connected accessories) towards surface you wish to steam, and
press Steam Trigger. Hold Trigger down for a continuous flow of steam.
CAUTION: Always be sure that Jet Nozzle and other accessories are pointed in a safe
direction (away from yourself, other people, pets, and plants) before pressing Steam
Trigger.
NOTE: When steaming any surface for the first time, it is recommended that you consult
the manufacturer's guidelines for material being steamed. For items in question, test
steam on an inconspicuous area before proceeding.
4. Using a slight back-and-forth motion over the area you are steaming will enhance the cleaning
process, as will scrubbing the area (if a Brush is connected). Wipe steamed areas with a
clean cloth to remove loosened dirt and grime.
CAUTION: Wiping an area while it is still wet is recommended, but use care when wiping
surfaces such as metal that may still be hot.
5. To effectively kill bacteria and other microorganisms, hold Jet Nozzle (and any connected
accessories) approximately 1/2 inch from surface and press Steam Trigger. Keep Trigger held
and concentrate steam on the same spot for at least 5 seconds.
6. At its maximum capacity (6 oz / 180 ml), the Boiler will provide approximately 8 minutes of
continuous steam. If you wish to continue steaming, refer to Filling Boiler procedure on
Page 9 – be sure to note Refilling Boiler section at bottom of page.
7. Once you are finished using your Everyday Steam Cleaner, immediately unplug power cord
from electrical outlet. Refer to Storage & Care guidelines on Page 11 for proper cleaning and
storage procedures.
10 | ENGLISH
Using Your
Everyday Steam Cleaner