Led Diagnostics; Hedge Trimmer Status; Charge Status - Stihl HSA 45 Manual De Instrucciones

11 LED Diagnostics

To charge the hedge trimmer:
► Remove the activation key, @ 12.2.
1
2
► Insert the charger plug into a properly installed wall
outlet (6) with the same voltage and electrical frequency
stated on the charger's rating plate (5).
► Push the connector (3) into the hedge trimmer's charging
socket (2) until it stops.
The LEDs on the hedge trimmer (1) glow green during
charging and show the state of charge.
When the LEDs on the hedge trimmer go out, the charging
process is complete and the charger will shut itself off.
► Remove the charger from the hedge trimmer and
disconnect the charger plug from the wall outlet when
charging is complete.
A new hedge trimmer is not fully charged. STIHL
recommends that you fully charge the hedge trimmer before
using it for the first time.
Operate the charger only indoors, in dry rooms and within an
ambient temperature range of 32 °F to 104 °F (0 °C to
40 °C).
The hedge trimmer heats up during operation. The charging
process begins only after the hedge trimmer and its
integrated battery have cooled down sufficiently.
Charging time depends on a number of factors, including the
condition of the integrated battery and the ambient
temperature. For a complete list of approximate charging
times, see www.stihl.com/charging-times.
0458-717-8621-A
6
5
3
4
Operation of the hedge trimmer is disabled during charging
and any time the hedge trimmer is connected to the charger.
11 LED Diagnostics

11.1 Hedge Trimmer Status

LEDs on the hedge trimmer show the status of the power
tool and its integrated battery.
If three LEDs glow red continuously: the integrated battery
is either too hot or too cold. Allow the hedge trimmer to warm
up or cool down gradually at an ambient temperature of
about 50 °F to 68 °F (10 °C to 20 °C).
If three LEDs flash red when you activate the switch lever
and trigger switch: the hedge trimmer has an electrical
malfunction. Do not operate or charge the hedge trimmer.
Have it checked by an authorized STIHL servicing dealer
before use or storage.
For troubleshooting information, @ 21.

11.2 Charge Status

The LEDs also show the hedge trimmer's state of charge.
To determine the hedge trimmer's state of charge:
1
► Press the push button (1) on the hedge trimmer.
The LEDs on the hedge trimmer will glow or flash green
for about 5 seconds and indicate the state of charge (see
illustration).
English
80-100%
60-80%
40-60%
20-40%
0-20%
19