Tool Setup; Operating Instructions; Nose Equipment; Fitting Instructions - Stanley ProSert XTN20 Manual De Instrucciones

Ocultar thumbs Ver también para ProSert XTN20:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

E N G L I S H

3. Tool Setup

IMPORTANT - READ THE SAFETY RULES ON PAGE 6 & 8 CAREFULLY BEFORE PUTTING INTO SERVICE.
Before Use
Select relevant size nose equipment and install.
Connect the placing tool to the air supply. Test pull and return cycles by depressing and releasing the
trigger 20.
Set the tool for desired stroke/pressure.
CAUTION - correct supply pressure is important for proper function of the installation tool. Personal injury or
damage to equipment may occur without correct pressures. The supply pressure must not exceed that listed in
the placing tool specification.

4. Operating Instructions

IMPORTANT - READ THE SAFETY RULES ON PAGE 6 & 8 CAREFULLY BEFORE PUTTING INTO SERVICE.
IMPORTANT - THE AIR SUPPLY MUST BE TURNED OFF OR DISCONNECTED BEFORE FITTING OR
REMOVING THE NOSE ASSEMBLY.
4.1 Nose Equipment (see Fig.2).

Fitting Instructions

Item numbers in bold refer to nose assembly components in fig 1.
Air supply must be disconnected.
If still fitted, remove the Nose Casing 4 and the Chuck Nut 5,while pulling back the spring loaded Nose
Rod 9.
Insert Drive Shaft 7 into Mandrel Adaptor 8.
Fit Mandrel 1 onto Drive Shaft 7.
Insert Reducing Sleeve 6 (if specified) into the Chuck Nut 5.
Screw the Chuck Nut 5 onto the Mandrel Adaptor 8 while pulling back the spring loaded Nose Rod 9.
Tighten the Chuck Nut 5 clockwise.
While holding the Tool, screw on the Nose Casing 4 and Nose Tip 2 with the nose tip Lock Nut 3.
The reverse operation is carried out for equipment removal.
With the tool still disconnected from the air supply, screw a Blind Rivet Nut onto the Mandrel manually.
Position Nose Tip 2 on the Nose Casing 4 and lock it with Lock Nut 3 so that the Mandrel 1 protrudes
slightly beyond the insert.
Lock the Lock Nut 3 by turning clockwise with a spanner*. Remove the Blind Rivet Nut from Mandrel.
*Refer to items included in the Maintenance Kit 07900-09301 page 15.
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

74202

Tabla de contenido