TRAPP Master 1000 Manual De Instrucciones página 22

Never transport the side brush cutter Master

1000 and master 3000 by the extension cord.
Keep the brush cutter model Master 1000 and

Master 3000 in good working conditions - When
not being used, keep the equipment in a dry
place, protected from the weather, away from
children and people not familiarized with it.
Never use a water jet to clean the brush cutters

models Master 1000 and Master 3000; clean
them with a sponge or cloth soaked in neutral
detergent. With the equipment turned off.
Keep safety devices at proper places and in

good working conditions. According to manual
instruction on page 27.
If the brush cutter model Master 1000 and

Master 3000 throws a foreign object - Follow
these steps:
a. Immediately turn it off.
b. Remove the extension cord from the wall
outlet.
c. Review the extension cord of the brush cutter
model Master 1000 or Master 3000 for
damages.
d. Fix any damage before switching it on again.
Keep the spool filled with nylon thread always in

conditions of use. Never use steel wire to replace
the nylon thread (only for brush cutter model
Master 1000).
After the equipment is off, the spool continues in

movement during a few seconds up to complete
stop. Pay attention to it when performing any type
of maintenance (only for the brush cutter model
Master 1000).
Use the equipment and accessories in accordance

with the instructions herein, considering the
work conditions and the service to be performed.
The use of equipment for operations not contained
herein can result in dangerous situations.
22
Attention!
The use of equipment without the protection
device.
2 - Service
The repairs in the equipment must only

be performed by qualified professional
and with TRAPP
Always use the services from the TRAPP
Authorized Technical Assistants. TRAPP is
not liable for possible damages caused to the
equipment or accidents that may occur due to
the use of not original parts.
To reduce the risk of accidents - Frequently

inspect the brush cutter model Master 1000 and
Master 3000, and if there are traces of wear out
or deterioration, provide the substitution of parts.
Beware of injuries to your feet and hands caused

by the cutting means.
Always make sure that the ventilation openings

from the engine fairing are free of debris.
Regularly inspect and maintain the equipment.

Conduct reviews and maintenances by authorized
people only.
Attention!
If the power supply cord is damaged, it shall be
replaced by the TRAPP Authorized Technical
Assistance in order to avoid the risk of accidents.
www.trapp.com.br
Original Parts -