TRAPP Master 1000 Manual De Instrucciones página 31

www.trapp.com.br
Before turning it on, always verify if the voltage
of the brush cutter matches the power supply
voltage.
With the brush cutter on the floor, bend the

extension (1) next to the female plug, leaving
enough size to connect to the engine outlet male
plug (2).
Couple the bending in the lock extension (3),

according to next figure and only then connect
the extension male plug in the power supply.
Only for Three-Phase Version - Master 3000
Verify if the voltage of the power supply is the

same as the equipment (220 or 380 V).
Standardize the wall outlets which the machine

will use, preferably choosing those with guide-pin.
Install the male plug in the brush cutter and

make a test: turn it on and off in order to verify
the rotation direction. The correct rotation is
counterclockwise.
If the rotation direction is wrong, alter the

position between the wire phases of the machine
outlet (this work is recommended to a qualified
professional).
With the purpose of providing maximum safety
to the operator, TRAPP implemented in the brush
cutter Master 1000 an ON/OFF switch of double
activation. It work as follows (figure 5):
To turn on the brush cutter just activate the switch

1 and the switch 2 together.
Attention!
Releasing both switches the brush cutter will

turn OFF.
Where to Turn it On



Switch - Master 1000
Switch 2
When the rotation is right, standardize all wall
outlets and test again.
Also standardize the extensions.
The rotation in the wrong direction may release
the blade and cause severe accidents. Refasten
the nuts that fixate the blade.
Note:
This test and the standardization are
necessary only for the three-phase model.
Figure 5
Switch 1
31