Iv-4-Passing Cables - Bombard SUNRIDER 500 Manual Del Propietário

INSTALLATION AND CIRCUIT - Passing the cables

IV-4-PASSING CABLES

Prepare the end of the steering cable.
Thread the steering cable into the back of the hull towards the front
after having fixed the sleeve protecting the rack. Pull it out from the
console.
Venue is an engine command cable to which a 5 m halyard has been
attached to be used as a puller.
Pass all wires and cables in this way into the hull.
Page 26 of 35
But the engine control box onto the
console trying to position it straight
so that the cables are naturally bent.
Pull the engine cables connected to
the control box by the hole made in
the deck. Think to switch the
electric connection plug to the
engine that leaves the box passing
through the hole. Attach a wire
puller, and pull it out from behind.
Make the various connections with
the engine control box. Fix this box
to the console.