Assembly Of Options - Bombard SUNRIDER 500 Manual Del Propietário

ASSEMBLY OF OPTIONS – Roll-bar
V-1- ROLL-BAR ASSEMBLY
F
View on F
Vue suivant F
Mark and drill the 2 x 2 holes, dia. 10.5 mm,
in the templates, using the holes
on the roll bar as a guide.
Position, mark and block the template
(e.g.: hot melt cement) up against the
vessel's transom.
Prepare 2 drilling templates (min. thickness: 25 mm)
Assemble the roll bar. Block the roll bar in position as
shown on the figure below.
Support
Equerre
bracket
Page 33 of 35
F
View on F
Vue suivant F
E
N
G
L
I
S
H