Important Safety Instructions - Janome 8048 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

CAUTION
When using an electrical appliance, basic safety precautions should always be followed, including
the following:
Read all instructions before using this appliance.
DANGER
– To reduce the risk of electric shock:
1. An appliance should never be left unattended when plugged in. Always unplug this sewing
machine from the electric outlet immediately after using and before cleaning.
2. Always unplug before replacing a sewing machine bulb. Replace bulb with same type rated
12 Volts, 5 Watts.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
–
1. Do not allow this sewing machine to be used as a toy. Close attention is necessary when this
sewing machine is used by or near children.
2. Use this appliance only for its intended use as described in this owner's manual.
Use only attachments recommended by the manufacturer as described in this owner's
manual.
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water.
Return this sewing machine to the dealer where it was purchased for examination, repair,
electrical or mechanical adjustment. Or, contact Janome America Inc. at the address on
the warranty card.
4. Never operate the appliance with any air opening blocked. Keep ventilation openings of
this sewing machine and foot controller free from accumulation of lint, dust and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
8. To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the sewing
machine needle.
11. Always use the proper needle plate. The wrong plate can cause the needle to break.
12. Do not use bent needles.
13. Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
14. Switch this sewing machine off ("O") when making any adjustment in the needle area,
such as threading the needle, changing the needle, threading the bobbin or changing the
presser foot, and the like.
15. Always unplug this sewing machine from the electrical outlet when removing covers,
lubricating, or when making any other adjustments mentioned in this owner's manual.
SAVE THESE INSTRUCTIONS
All manuals and user guides at all-guides.com
I