Chapter 5: Windows 98 Installation And Setup; Overview; Windows 98 Driver Installation - Linksys USB200M Guia Del Usuario

Chapter 5: Windows 98
Installation and Setup

Overview

After physically connecting the Adapter to your computer's USB port or hub,
follow these instructions to install the hardware device driver. The installation
procedure for the hardware device driver may vary slightly depending on which
version of Windows 98 you are using, and on your current system
configuration. If at any time during the installation you encounter problems,
consult "Appendix A: Troubleshooting."

Windows 98 Driver Installation

1. If you haven't already, start your computer.
2. Windows 98 will automatically detect the Adapter connected to your PC.
When the first Add New Hardware Wizard screen appears, insert the Driver
CD into your CD-ROM drive, and click the Next button.
3. Select Search for the best driver for your device (Recommended), and
click the Next button.
Figure 5-1
Note: Throughout this guide, it is assumed that "D" is the letter of
your CD-ROM drive.
6
Instant EtherFast ® Series Compact USB 2.0 10/100 Network Adapter
4. Select Specify a location: to find the correct driver, and enter D:\win98 in
the field provided. Click the Next button to continue.
Figure 5-2
5. When Windows notifies you that it is ready to install the driver files, click
the Next button to continue.
Figure 5-3
Note: Do not click Cancel at any time during the installation
process. Doing so will prevent your driver from being properly
installed on your PC.
7