Dremel MM50 Instrucciones De Funcionamiento Y Seguridad página 9

1600A014GX MM50 08-18.qxp_MM50 8/23/18 9:10 AM Page 9
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
always wear protective gloves. Such
preventive safety measures reduce the risk of
injury from sharp edges of the accessories.
Application tools can become very hot while
working. Danger of burns!
INSTALLING ACCESSORIES WITH
EASY-LOCK ACCESSORY CHANGE
OPM or greater. Using accessories not
designed for this power tool may result in
serious personal injury and property damage.
The Dremel Multi-Max MM50 was designed
with an integrated accessory change
mechanism. The Easy-Lock accessory
interface allows you to install and remove
accessories without the need of a wrench or
hex key.
1. To install an accessory using the Easy-
Lock feature, first loosen the clamping
knob by twisting it in a counter-clockwise
direction (Fig. 2).
2. Press the clamping knob so that the
clamping flange extends enough to fit a
blade in between the clamping flange and
the interface. You may need to loosen the
clamping knob more to allow adequate
room for the accessory. (Fig. 3)
3. Place the accessory onto the interface,
making sure the accessory engages all
pins on the interface and the accessory is
flush against the accessory holder (Fig. 4).
4. Release pressure on the clamping knob.
The spring action of the mechanism will
hold the blade in place while you secure it
(Fig. 5).
5. Tighten the clamping knob by twisting in a
clockwise direction (Fig. 2). Make sure to
tighten fully, until you can't twist the
clamping knob
uncomfortable).
Assembly
Disconnect the plug from
the power source before
For all work or when
changing accessories
Only use Dremel
accessories rated 21000
(without it being
FIG. 2
Clamping
Knob
FIG. 3
FIG. 4
Accessory
FIG. 5
-9-
Pins
Flange