Carbon Filter; Bulb Replacement; Important; Changing The Light - Candy CBT6130/3X Manual De Instrucciones

CARBON FILTER

Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
1. Put the carbon filter on the back side of the aluminium filter.
2. Insert the steel wire into the frame of the aluminiu m filter, one on each side. Y ou
need to bend it to insert into the other end of the frame.
3. Make sure the steel wire fix the carbon filter onto the aluminium filter.
NOTE:
 Make sure the filter is securely locked. Otherwise, it would loosen and cause
dangerous.
 When activated carbon filter attached, the suction power will be lowered.

BULB REPLACEMENT

Important :

Changing the light

Use the screw driver loosen the ST4*8MM self tapping screw (2pcs) from the lighting
panel, take out the lighting fixture. Open the terminal box that connected with the wire,
disconnect the wire connector and replace the lamp.
• ILCOS D code for this lamp is: DBS-2/65-H-120/33
– LED modules –rectangle lamp
– Max wattage: 1X2 W
– Voltage range: AC 110-240V
– Dimensions:
 The bulb must be replaced by the manufacturer , its
service agent or similarly qualified persons.
 Always switch of
carrying out any operati ons on the appliance. When
handling bulb, make sure i t is compl etely cool down
before any direct contact to hands.
 When handling gl obes hold wi th a cloth or gloves to
ensure perspi ration does not come in cont act with
the globe as this can reduce the life of the globe.
f the el ectricity suppl y before
11