Balluff BTL6 Serie Instrucciones Breves página 6

BTL6-A500/B50 _ -M _ _ _ _ -E2/E28-KA _ _/LA _ _-ZA0 _
Micropulse AT transducer in round profile housing
Installation
NOTICE!
Interference in function
Improper installation can compromise the function of the
transducer and result in increased wear.
f The mounting surface of the transducer must make
full contact with the supporting surface.
The bore must be perfectly sealed (O-ring/support
f
ring).
The BTL transducer can be fastened in a fitting bore
(Ø 48 H8), but must be sealed with the provided O-ring
and support ring.
The body of the transducer is fastened using 3 M5
threaded pins at a 120° angle.
If installing horizontally with nominal lengths > 500 mm,
we recommend tightening the outer rod at the end (only
possible with Ø 10.2 mm) or supporting it.
If installed in a hydraulic cylinder, the magnet should not
make contact with the outer rod. Minimum bore diameter
in the support piston:
Tube diameter
10.2 mm
8 mm
Square flange
M12x1
The square flange is included in the scope of
delivery.
2 english
Bore diameter
At least 13 mm
At least 11 mm
Mounting hole
Hydraulic cylinder
Installation in hydraulic cylinders
1. Lead the M12 contact insert through the bore and out
of the cylinder.
2. Position the square flange on the M12 contact insert
and engage it.
M12 contact insert
Top view
3. Fasten the square flange to the hydraulic cylinder using
4 screws. When installed, the connector complies with
protection category IP67.
Square flange