English
10
Machine overview
1 Power-on light
2 Steam ready light
3 Machine ready light
4 Selection knob
5 Ground coffee filter
6 Pressurized filter holder
7 Brew unit
8 Drip tray cover (specific types only)
9 Drip tray
10 User interface
11 Cup holder rest
12 Water tank
13 Lid of the water tank
14 Ground coffee measuring scoop
15 Pod filter adapter (specific types only)
16 Coffee pod filter (specific types only)
17 Seat for accessories
18 Seat for coffee measuring scoop
19 Hot water/steam knob
20 Classic milk frother (specific types only)
21 Power cord
22 Main switch (RI8437, RI8435, RI8433) with energy saving switch)
First installation
1 Remove all packaging material from the machine.
2 Place the machine on a table or worktop away from the tap, the sink and heat sources.
Note: Leave at least 15 cm of free space above, behind and on both sides of the machine (Fig. 2).
Preparing for use
1 Remove the lid of the water tank and remove the water tank from the machine (Fig. 3).
2 Rinse the water tank. Fill the water tank with fresh water up to the MAX indication (Fig. 4).
3 Place the water tank back into the machine and push it downwards until the reference marks are
visible (Fig. 5).
4 Place the lid of the water tank back onto the machine.
Circuit priming
When you use the machine for the first time, after dispensing steam or when the water tank is empty,
perform the following steps:
1 Place a container under the milk frother and turn the hot water/steam knob anticlockwise (Fig. 6).
2 Insert the mains plug into a wall socket.Set the main switch to 'I' to switch on the machine (Fig. 7).
-
The power-on light lights up.
3 Turn the selection knob to the coffee position (Fig. 8).
-
Hot water comes out of the milk frother.
4 When the water tank is empty, turn the selection knob back to the standby position (Fig. 9).
5 Turn the hot water/steam knob clockwise. Remove the container (Fig. 10).
Gaggia Viva WEU_export_30029_72.indd 10
21/12/2018 10:55:48