Environmental Protection - BGS technic 70009 Manual De Instrucciones

SAFETY INFORMATIONS
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage and personal injuries.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
After repair or before starting the engine, turn a minimum of 2 turns by hand and check the
timing again.
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
•
Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulley, camshaft or crankshaft. This can damage tools and engine
components. Only use tools that are suitable for this purpose.

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information. Dispose
of this product at the end of its working life environmentally.
USE
Counter-Holding Tool for Crankshaft Pulley,
to be used as OEM 999 5433
Is required to loosen the central screw on the crankshaft
pulley.
Crankshaft Locking Pin,
to be used as OEM 999 7005
Inserting laterally into the engine block and is used to
adjust and fix the crankshaft in the setting position.
Camshaft Locking Pin,
to be used as OEM 999 7007
Inserting into the cylinder head bore and is used to adjust
and fix the camshaft in the setting position.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed