Important - Klarstein TRIFECTA Manual De Instrucciones

Important!

• The gas hose must be inserted outside the red wire of the universal air inlet
connector and secured with a clamp!.
• There must be a sealing rubber ring in the intake elbow and the gas connection
pipe to be installed and used!.
Gas leakage detection
Soap water leakage detection:
Apply a soft brush to the joints with soapy water and open the gas valve to see if
bubbles are generated. If there is air bubble, please close the gas valve immediately,
adjust the leak connection and try again until no air bubbles are generated.
Installation for battery
The battery compartment cover is located on the lower right side of the front side of the
product case. Please insert the supplied 1 or 2 section batteries correctly into the battery
case according to the positive and negative indications. To ensure long-lasting ignition
system, use a high-energy alkaline battery. If the ignition frequency is slowed down
during use, please change the battery in time.
Installation for pan support, burner cap and burner
• Make sure that the knob, burner set and pan support are properly installed.
Improper installation can seriously affect the normal use of the product and shorten
the life of the product.
• When installing the burners, make sure that the burner mounting holes are inserted
in the ignition pin and thermocouple. During installation, make sure that the stainless
steel surfaces of the appliance are not scratched by the individual appliance
components or that you accidentally break off the ignition pin. Damage caused in
this way is not covered by the warranty.
Metal bellows
EN
37