Cadel Thermostove 28 Manual De Instrucciones página 3

Charge pellet
Fuel is loaded from the upper part of the stove by
opening a door. Pour the pellets in the hopper.
This is easier if performed in two steps:
• Pour half of the contents of the bag into the
hopper and wait for the fuel to settle on the
bottom.
• Then pour in the second half;
• Keep the cover closed , after loading the pellets
, the lid of the fuel tank;
The thermostove is a product by heating, presents
the external surfaces particularly hot. For this
reason, we recommend extreme caution when
operating in particular:
• Do not touch the stove body and the various
components, do not approach the door , it could
cause burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come near;
• Use only wood pellets;
• Keep / store the pellets in a cool dry place;
• Never pour pellets directly on the hearth;
• The thermostove must only be fed with quality 6 mm diameter pellets, A1 certified
according to the UNI EN ISO 17225-2 regulations;
• Before making the electrical connection of the thermostove the discharge tubes must be
connected with the flue;
• The protective grill placed inside the pellet container must never be removed;
• The environment where the stove is installed must have a sufficient exchange of air;
• It is forbidden to operate the thermostove with the door open or the glass broken;
• Do not use the thermostove as an incinerator; the thermostove should be used only for
the intended purpose;
• Any other use is considered improper and therefore dangerous. Do not put in the hopper
other than wood pellets;
• When the thermostove is operating, the surfaces, glass, handle and tubes become very
hot: during operation do not touch these parts without adequate protection;
• Keep the fuel and other inflammable materials off the thermostove.
Never remove the protection grille
in the hopper. When filling, do not
let the sack of pellets touch any
hot surfaces.
3