To Lubricate The Gear Housing; To Examine The Blades; To Clean And Lubricate The Blades; Troubleshooting - McCulloch SUPERLITE 4528 Manual Del Usuario

To lubricate the gear housing

• Use McCULLOCH special grease. Speak to
your servicing dealer for more information about
recommended grease.
• Add the grease through the lubricant filler cap on the
gear housing.
CAUTION:
fully.

To clean and lubricate the blades

1. Clean the blades from unwanted materials before
and after you use the product.

Troubleshooting

The engine does not start
Problem
Starter pawls
Fuel tank
Carburetor
No spark
Spark plug
1255 - 003 - 10.03.2022
Do not fill the gear housing
Troubleshooting
Possible cause
The starter pawls cannot
move freely.
Incorrect fuel type.
Incorrect idle speed.
The spark plug is dirty or
wet.
Incorrect electrode gap.
The spark plug is loose.
2. Lubricate the blades before long periods of storage.
Note:
Speak to your servicing dealer for more
information about recommended cleaning agents and
lubricants.

To examine the blades

1. Remove the lubricant filler cap on the gear housing.
2. Make sure that the blades move freely. Put the
combination wrench in the gear housing and turn
clockwise and counterclockwise.
3. Examine the edges of the blades for damages and
deformation.
4. Use a file to remove burrs on the blades.
Recommended step
Adjust or replace the starter pawls.
Clean around the starter pawls.
Speak to an approved servicing dealer.
Drain it and use correct fuel.
Adjust the idle speed.
Make sure that the spark plug is dry and clean.
Clean the spark plug. Make sure that the electrode gap
of the spark plug is correct. Make sure that the spark
plug is installed with a suppressor.
Technical data on page 14 for correct elec-
Refer to
trode gap.
Tighten the spark plug.
13