decorflame QCM270-50D Manual De Instrucciones página 3

S A F E T Y
This electric fireplace heater is for use on
120 volts. The cord has a plug as shown
at A in Figure 1. An adapter as shown at
C is available for connecting three-blade
grounding-type plugs to two-slot recep-
tacles. The green grounding plug extend-
ing from the adapter must be connected
to a permanent ground such as a properly
grounded outlet box. The adapter should
not be used if a three-slot grounded
receptacle is available.
Procedures and techniques if not carefully
followed - will result in damage to the
equipment. - will expose the user to the
risk of serious injury, illness or death.
NOTE: The electric fireplace heater may
emit a slight harmless odor when first
turned on. This is caused by activating the
internal heater components for the first
time and should not occur again.
All manuals and user guides at all-guides.com
I N S T R U C T I O N S
CAUTION
If you use this heater in conjunction with
a thermal control, a program controller,
a timer or any other device that switches
the heater on automatically, remember to
observe all safety warnings at all times.
The heater has safety overheat protection.
If the overheat protection trips, switch off
all switch buttons and wait approximately
5 -10 minutes. It should reset automati-
cally once the unit cools down.
A 15 AMP circuit to operate this heater. If
the breaker trips when the heater is used
then you may need to move the heater to
another location or unplug other appli-
ances that are on the same circuit. If you
require an extension cord use one that is
rated at 1875 watts.
IMPORTANT
Please note when you open the carton
carefully check the unit and make sure
there are no damages. If you have any
problems with assembling the unit, with
how the various functions work or with
hidden damages or missing parts please
call 1-800-459-4409 (EST) immediately for
service.
NOTE: DO NOT RETURN UNIT
TO THE STORE BEFORE CALL-
ING THE TOLL FREE NUMBER.
Do not dispose of you cartons until you are
completely satisfied with your new fireplace
heater.
NOTE: Light bulbs may become loose during
shipping. If the flame effect is dim or does not
work, please check that light bulb or bulbs
are finger tight in socket. See instructions for
replacing bulb or bulbs. Please do not return
the sample to the store before checking light
bulbs.
3