decorflame QCM270-50D Manual De Instrucciones página 6

A S S E M B LY I N S T R U C T I O N S
Step 9: Tighten all SCREWS. See Fig. I
FIREPLACE INSERT
INSTALLATION
The fireplace insert can be installed after the
mantle has been fully assembled.
WARNING: Make sure the fireplace insert
controls are in the OFF position and the unit
is NOT plugged in.
Step 1: Place the INSERT on the floor,
directly in front of the MANTLE. (The front of
both the mantle and insert should be facing
the same direction.)
Step 2: Carefully lift the insert into the
mantle opening. The front of the INSERT
should be flush with the front of the mantle.
See fig. J
All manuals and user guides at all-guides.com
fig. H
Step 3: Once the INSERT is in place, attach
MOUNTING BRACKET (V) to the bottom with
4 MED-KD SCREWS (W). See fig. K
fig. I
Step 4: Attach 2 MOUNTING CLIP (U) on
the top of the INSERT. Attach 4 MOUNTING
SCREWS (S) with the INSERT as shown in
Fig. L and 2 SHORT KD SCREWS (T) with the
MANTEL UNIT as shown in Fig. M
6
fig. J
fig. K
fig. L
fig. M