decorflame QCM270-50D Manual De Instrucciones página 4

A S S E M B LY I N S T R U C T I O N S
PARTS LIST:
Fireplace insert 1
A) Top panel 1
B) Base panel 1
C) Front Base 1
D) Left Side panel 1
E) Right Side panel 1
F) Left Front panel 1
G) Right Front panel 1
H) Right Small panel 1
I) Left Small panel 1
J) Upper Front panel 1
K) Mid-Front panel 1
Q) KD Nuts 4
R) KD screws 61
S) Mounting Screws 4
T) Short KD Screws 2
U) Mounting Clips 2
V) Mounting Bracket 4
W)Med-KD Screws 4
X) Plastic Connector 16
Y) SELF REPAIR SET
Touch-up repair paint (bottle)
L shape bracket 8
Screws for L shape 32
Plastic connector 1
KD screws 3
KD nuts 3
Z) WALL ANCHOR
SAFETY CABLE
Wall anchor 1
Screw for wall anchor 1
Screw for mantle 1
Safety cable 1
MANTLE ASSEMBLY:
CAUTION: Place a piece of cardboard or
protective sheet on the floor in order to avoid
scratching the decorative surface of your
mantle during assembly.
Please DO NOT fully tighten the KD screws
until all panels are assembled.
NOTE: If the KD screw(s) do not fit during
assembly, loosen the 2 screws to adjust
the Plastic Connector until the PANEL/KD
SCREWS are able to be installed. Tighten all
KD screws once all panels are assembled.
Step 1: Attach all PLASTIC CONNECTORS (X) to
the PANELS (D, E, H, I and J) as shown in Fig.
A. (2pcs KD SCREWS for each CONNECTOR)
All manuals and user guides at all-guides.com
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER
Step 2: Attach the FRONT BASE (C) to the
BASE PANEL (B) with 4 KD SCREWS and KD
NUTS (Q). Fig. B
4
fig. A
fig. B