decorflame QCM270-50D Manual De Instrucciones página 7

Step 5: Move assembled unit to desired
location. Unit should not be positioned in an
area exposed to direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE
may reduce possible risk of injury if the
fireplace is improperly handled, but is not
a substitute for proper adult supervision.
Children should not be left unattended near
any heater.
1. Drill a 5/16" (8mm) hole in the wall. Insert
the PLASTIC WALL ANCHOR into the hole
and gently tap until the flange on the anchor
is against the wall surface.
2. Position the back edge of the mantle
close to the wall.
3. Attach the SAFETY CABLE to the mantle
using the SCREW FOR MANTLE. See fig. N
4. Use the SCREW FOR WALL to attach the
other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
All manuals and user guides at all-guides.com
O P E R A T I O N
Once the fireplace heater has been properly
installed to the mantel, plug the fireplace
into a 15AMP/120 Volt outlet. If the cord
does not reach you may use an extension
cord rated for a minimum of 1875 WATTS.
Note: Every time the electric heater is
plugged in, it will beep once. This means
the heater has connected to the power
outlet. The Electric Fireplace Heater is
ready to operate. Note: ensure the circuit
breakers for the power supply are turned
on. The electrical fireplace heater can
be operated by the control panel and
operated by the remote control. See the
following:
OPERATION BY THE
CONTROL PANEL
ON/OFF: Press this button for main
power function. The unit will beep and the
indicator light will be on. Pressing again
will stop the main power function.
FLAME/LOG: Press this button once for
flame effect. The unit will be beep and the
indicator light will be on. The bulbs for
flame effect & log-set will be on. Pressing
button again will stop the light function.
750W: Press this button for low heat level.
The unit will beep, the pilot light and indi-
fig. N
cator light will be on. The fireplace heater
will give low heat level. Pressing once
again will stop the low heat level function.
1500W: Press this button for high heat
level. The unit will beep, the pilot light and
7