Filter Assembly - Hoover WindTunnel Dual V Manual Del Propietário

Filter assembly

The HEPA cartridge filter and pre-filter
are essentially self-shedding.
Tapping the side of the dirt cup as
described in "How to empty dirt cup"
should sufficiently remove dust and fine
particles from the HEPA cartridge filter
and pre-filter.
The filter assembly can also be
removed for additional cleaning.
3-8
Clean the HEPA cartridge filter by tap-
ping either of the ends. DO NOT tap
soft pleated sides of HEPA cartridge
filter as this could damage the filter.
Tap filter until no more dust particles fall
from the filter.
3-11
Slide filter assembly down into cup until
a light snap is felt. Gently pull up on
assembly to ensure that it is seated
properly in the cup. Ensure that no part
of pre-filter screen extends above top
edge of dirt cup.
Replace lid and return cup to cleaner
(Fig. 3-4).
Note: If dirt cup lid does not close all
the way, ensure that filter assembly is
pushed down all the way. Turn knob on
lid until lid closes (Fig. 3-3).
All manuals and user guides at all-guides.com
How to clean filter
assembly
3-6
Remove dirt cup and dirt cup lid as
described in "How to empty dirt cup."
Grasp pre-filter frame and pull up firmly.
Slide filter assembly out of cup.
3-9
To re-assemble filter assembly, place
large knob of HEPA cartridge filter in
hole on bottom of pre-filter.
Snap top of HEPA cartridge filter into
place.
Cleaning final filter
3-12
K
J
The final filter assists in returning clean
air to the room.
To remove this filter when it becomes
dirty, lay handle flat on the floor. Press
door tab (J) and remove door.
Lift out filter (K) and hand wash it in cold
water with mild detergent.
3-7
C
Grasp end of HEPA cartridge filter and
pull it away from pre-filter. Remove
cartridge from assembly.
The pre-filter (C) can be cleaned with a
brush and then rinsed with water. Allow
pre-filter to dry thoroughly.
3-10
H
I
Align grooves (H) on pre-filter frame with
grooves (I) in dirt cup.
Let filter air dry and reposition it.
Replace door. Snap closed.
Should you want to replace this filter, ask
for HOOVER part No. 38766028.
Do not operate cleaner without the fil-
ter in place.
Continued
9