Setting The Cutting Height - Tramontina CC45M Manual De Uso Y Mantenimiento

EN
The lack of oil, insufficient oil, excessive oil or oil different from the recommended one cause
damages to the engine and make the warranty void.
Gas
Always use good quality gas and do not store it for more than 30 days, since this can damage the engine
operation.
The tank has capacity for 1 L for 6 hp engines, and 750 ml for 4 hp engines.
Let the engine cool for at least two minutes before refilling with gas so as to avoid the possibility of an explosion.
Never leave gas in the tank. Use the lawn mower until the gas finishes in order to prevent it from accumulating
in the carburetor.
Do not mix oil in the gas.
Drive
Engines equipped with "primer" fuel injector, press 3 times before the start-up.
Actuate the braking lever (1), [Fig. 11, page 05].
Pull the driving cord until feeling a resistance and then pull it strongly (2), [Fig. 11, page 05].
The work is performed keeping the lever pressed to the arm (4), [Fig. 12, page 05].
To turn off, release the lever and the engine will stop immediately (5), [Fig. 13, page 05].
Use on step terrain
Please see slope inclination limits for these lawn mowers in the table below:
Engine
4 hp
6 hp

Setting the cutting height

To achieve a close cut, the terrain should be flat and even with no holes, otherwise the blade might touch the
ground, which can hinder the engine's performance and damage the lawn. Settings can be found by the lawn
mower's wheels. To adjust the cutting height, move the setting lever, releasing it from the setting bar [Fig. 14]. Try
to use the same cutting height settingon the front and rear wheels of the lawn mower.
For any kind of maintenance, turn off the engine and disconnect the sparking plug cable.
Use
during continuous use
Domestic
Professional
Setting
the cutting
height
Fig. 14
MAINTENANCE
Maximum inclination
Up to 15º
Up to 15º
CC45M
24 mm
37 mm
50 mm
63 mm
13
Maximum inclination
during intermittent use
Up to 20º
Up to 30º
CC50M
24 mm
36 mm
49 mm
62 mm