End Of A Program (Automatic Or Manual); Extend A Cooking Cycle (Automatic Or Manual); Relaunch The Same Program; Relaunch A Different Program - TEFAL Cake Factory KD8121 Slim Manual De Instrucciones

EN
D. End of a Program
1 2
1. The time reaches 000 and the appliance beeps to signal the end of cooking.
2. Press OK once to stop the ring, the display 000 flashes.
3. The use of hand protection (oven glove) to prevent burns when handling hot dishes or moulds
is necessary.
Caution: It is important to open the appliance and to quickly remove the cakes so that they do
not continue to cook.
E. Extend a Cooking Cycle
1
3
34
(Automatic or Manual)
3
(Automatic or Manual)
1. At the end of the program, in
the event where the cake is
undercooked, it is possible to
increase the cooking time by
directly pressing the + and -
buttons. Close the cover again.
2. Once the additional time has
been entered, press Start to
2
continue cooking.
3. The time display stops flashing
and the minute-by-minute
countdown starts.
continues. The graphic on the
screen's left indicates that a
cooking cycle is under way and
that the appliance is heating.
F. Relaunch the Same Program
Automatic and Manual
×1
1
G. Relaunch a Different Program
After an Automatic Program
1
After a Manual Program
Cooking
1
1. After having turned off the beep, press the OK button a
second time to display the time. The last cooking time
used is displayed and flashes.
2. Press OK to start the program.
1. After having turned off the beep, press the Back button
to return to the program selection screen.
2. Please refer to Part A to choose the program.
1. After having turned off the beep, press the Back button
to return to the program selection screen.
2. Please refer to Part C to start the program.
EN
35