Using The Moulds; After Cooking - TEFAL Cake Factory KD8121 Slim Manual De Instrucciones

EN

Using the Moulds

To ensure the proper operation of your appliance, when filling the moulds, do not exceed the
proportions indicated.
Silicone PROflex Mould*
The Cake Factory is only compatible with moulds belonging to the Tefal PROflex range,
dimensions 30 x 21 cm.
Pour into the mould Remove the Ensure that the
aluminium bowl
black reflector is
properly in place
and attached to
the bottom of the
appliance
* To cook canelés or for any use of a mould taller than 4.5 cm, directly place the PROflex mould in the Cake
Factory without the support grid.
Non-stick aluminium bowl
Grease the bowl
Fill the bowl Remove the grid*
Steel moulds*
Fill the moulds up to 3/4.
Pour into Place the moulds Put the holder
steel moulds into the holder into the device
Mould shapes can be mixed if each of them respects same recipe and same quantity.
28
Place the grid on Place the mould Close
the reflector*
Insert the bowl Close
Ensure that the
black reflector is
properly in place
and attached to
the bottom of the
appliance
Close
*Depending on model

After cooking

Remove the support Place the support Remove the moulds
frame from the frame on a surface from the support
cake factory with suitable for heat frame one by one
oven gloves
Melting chocolate*
Place the chocolate Remove the grid Close
in the aluminium
mould
To melt chocolate, use the Cake Factory non-stick aluminium mould or the PROflex chocolate
melting silicone mould (if included).
Individual dairy desserts/mousses* **
Do not put the lids on the glass pots during cooking.
Pour into the Put the aluminium Put the glass pots
glass pots mould into the in the aluminium
device mould
Once the baking process is finished, remove the dish and the glass pots from the Cake Factory,
still hot, with the help of a potholder and leave to cool for 10 minutes before putting the lids on.
Let the jars cool down for 2 hours at room temperature before putting them in the refridgerator.
Dairy desserts/mousses to share*
Pour into Put the Close
the aluminium aluminium mould
mould into the device
Allow to cool for a
few minutes before
removing from the
mould.
Put chocolate in a Place the grid on Close
suitable container the reflector
Close
*Depending on model
**Depending on model, included or sold separately
(in a pack of 6, with mention "Cake Factroy").
EN
29