Team kalorik TKG MGR 1010 Manual De Instrucciones página 6

IMPORTANT INFORMATION
This appliance is not intended for professional use. You should follow the requested breaks.
Failure to follow this instruction carefully may result in damage to the motor.
ASSEMBLING
• Hold the head and insert it into the inlet with one hand, place the locking knob into
the hole on the side of the motor housing with the other hand, and tighten it
clockwise to secure the head.
• Place the feed screw into the head, long end first, by turning the feed screw slightly
until it is set into the motor housing.
• Place the cutting blade onto the feed screw shaft with the blade facing the front as
illustrated. If it is not fitted properly, meat will not be ground.
• Place the desired cutting disc next to the cutting blade, fitting protrusions in the slots.
• Support or press the centre of the cutting plate with one finger, then screw the fixing
ring until tight with the other hand. Do not overtighten.
• Place the hopper plate on the head and fix into position.
• Locate the unit on a firm place.
• The air passage at the bottom and the side of the motor housing should be kept free
and not blocked.
USE
• Cut all foods into pieces (sinewless, boneless and fatless meat is recommended.
Approximate size : 20 x 20 x 60 mm will fit easily into the hopper opening.
Plug in and turn the security lock to "On" position, then turn the "On/Off/Reverse"
•
switch to "On" position.
• Place foods into the hopper plate. Use only the food pusher to make it go down the
food chute.
• After use, switch the unit off and unplug it from the power supply.
Reverse
In case of jamming, switch the appliance off by turning the security lock to "R" position
and the "On/Off/reverse" switch to "R" position.
The feed screw will be rotating in the opposite direction, and the head will get empty.
If it doesn't work, switch the unit off and clean it.
CLEANING AND CARE
• Always unplug the appliance and let it cool down before cleaning it.
• Clean the plastic parts of the appliance with a soft cloth.
• Never use abrasive products.
• Never immerse the motor block into water or any other liquid.
• Clean the accessories with lukewarm water and some mild detergent, rinse and dry.
• Never put any part of your appliance in the dishwasher.
TKG MGR 1010 6