Omron HEM-907 Manual De Instrucciones página 10

Notes on Safety
Be sure to use the power supply of 230 VAC.
•
It may cause fire or electric shock.
Do not share an electric outlet with other unit or electric appliance.
Do not place this unit or other unit around an electric outlet after insert the AC adapter, as you should
remove the AC adapter in case of emergency.
•
It may cause fire or electric leak.
Do not pull the power cord when pulling out the AC adapter from the electric outlet.
•
The power cord will be disconnected or shorted and may cause fire or electric shock.
Do not install or store the unit where it may be sprayed with water or medication.
•
You may suffer electric shock.
•
Do not place or put anything on the unit.
•
Do not apply strong shock to or drop the unit.
•
When you move the unit, be sure to turn off the power and remove the connected AC adapter.
•
When using this unit concurrently with other unit, be sure to read the Instruction Manual of the other unit to be used
concurrently and understand the warnings and cautions before use.
•
Be sure to confirm that all cords and tubes are connected correctly and completely before use.
•
Inspect the Buttons and so on to confirm that the unit operates normally before use.
•
When using a battery pack, be sure to confirm that the voltage is sufficient before use. If you are not going to use the
unit for a long period of time, remove the battery pack.
•
Do not inflate the arm cuff without being wrapped over the arm.
•
Do not use a damaged arm cuff.
•
Do not use the unit in a vehicle.
•
Be sure to monitor all the time that the unit and the patient are not abnormal.
•
Please keep the unit out of the reach of patient.
•
Clean and store the unit and accessories after each use.
•
Do not clean the unit with gasoline, thinner, or high concentration alcohol.
•
Do not disinfect the unit by autoclave or gas sterilization (EOG, formaldehyde, or high concentration ozone.)
•
Do not store the unit in the following places.
· Under the direct sunshine
· Dusty or salty environment
· Places which slope, vibrate, and/or are prone to shocks
· Storage of chemicals or where gas may be generated
· Under high temperature and high humidity
10
Caution
Requests from OMRON