inbody 270 Manual De Instrucciones página 15

3. Stadiometer
If a stadiometer is connected to the InBody270, the height values measured by the stadiometer will be sent
directly to the InBody270.
* Always connect a stadiometer from InBody.
1) First turn off the InBody270 and then the stadiometer.
* You may experience connection issues in connecting the stadiometer to the InBody270 if the InBody is turned on.
2) Plug the serial cable provided with the stadiometer to the 9-pin serial port on the rear panel of the
InBody270.
3) Turn on the stadiometer.
4) Turn on the InBody270. Go to Setup in Administrator Menu and select 'Stadiometer' under «26. Serial
Connect». If the stadiometer is connected to the InBody270, the stadiometer icon (
on the top left corner of the screen when no one is on the footplate.
4. Blood Pressure Monitor
If a blood pressure monitor is connected to the InBody270, the blood pressure values measured by the
blood pressure monitor will be sent directly to the InBody270.
* Always connect a blood pressure monitor from InBody.
* If you select to print blood pressure measurements under Settings of the Administrator Menu «13. Outputs/Interpretations for Results
Sheet», the blood pressure measurements will be printed on the InBody Results Sheet.
1) First turn off the InBody270 and then the blood pressure monitor.
* You may experience connection issues in connecting the blood pressure monitor to the InBody270 if the InBody is turned on.
2) Plug the serial cable provided with the blood pressure monitor to the 9-pin serial port on the rear panel of
the InBody270.
3) Turn on the blood pressure monitor.
4) Turn on the InBody270. Go to Setup in Administrator Menu and select 'Blood Pressure Monitor' under
«26. Serial Connect». If the blood pressure monitor is connected to the InBody270, the blood pressure
monitor icon ( ) will appear on the top left corner of the screen when no one is on the footplate.
9-pin serial port
) will appear
9-pin serial port
EN
15