inbody 270 Manual De Instrucciones página 16

5. Barcode Reader
If a barcode reader is connected to the InBody270, the ID can be inputted automatically.
* If the InBody cannot recognize the barcode reader, please contact InBody.
1) First turn off the InBody270.
* You may experience connection issues in connecting the barcode reader to the InBody270 if the InBody is turned on.
2) Plug the USB cable of the barcode reader into the USB HOST port on the rear panel of the InBody270.
3) Turn on the InBody270. If the barcode reader is connected to the InBody270, the barcode reader
icon( ) will appear on the top left corner of the screen when no one is on the footplate.
6. SD400
Connect the SD400 to the InBody270 in order to connect the stadiometer and the blood pressure monitor
simultaneously.
1) Turn off the InBody270.
* For best result, the InBody270 should be turned off when connecting to thermal printer.
2) Connect the serial cable supplied with the SD400 to the 9-pin serial port on the rear panel of the
InBody270.
Then, connect the other end of the serial cable to the serial port of the SD400.
3) Connect your devices (such as stadiometer and blood pressure monitor) to the ports on the SD400 and turn
on the devices.
4) Turn on the InBody270. Go to Setup in Administrator Menu. Select 'SD400' under «26. Serial Connect»
and select the devices you have connected to the ports on the SD400. When your devices are connected,
the icons (
16
) of your devices will appear in the top left of the test standby screen.
USB HOST port
9-pin serial port