inbody 270 Manual De Instrucciones página 28

3. Rear Panel
Speaker: Provides audible indication for test in progress, test complete and successfully saved setting changes.
❶
9-pin COM serial port (Female, RS-232C): Used for connecting the InBody270 to LookinBody installed
❷
on a computer, a stadiometer, a blood pressure monitor and SD400.
The InBody270 can be connected to LookinBody installed on a computer using one of the ports
*
Only compatible with a InBody Stadiometer, Blood Pressure Monitor, and SD400.
*
LAN port (10T Base): Used for connecting the InBody270 to LookinBody installed on a computer.
❸
* The InBody270 can be connected to LookinBody installed on a computer using one of the ports
USB SLAVE port: Used for connecting the InBody270 to LookinBody installed on a computer.
❹
* The InBody270 can be connected to LookinBody installed on a computer using one of the ports
USB HOST port: Used for connecting to a printer, a barcode reader, or a USB Thumb Drive.
❺
Power Inlet: Used for connecting the power adapter.
❻
* Always use the adapter supplied by InBody Co., Ltd..
Power switch: Used to turn the device on/off.
❼
UTION NOTE
참 고 주 의
Do not touch signal input, signal output or other connectors, and the patient simultaneously.
•
External equipment intended for connection to signal input, signal output or other connectors, shall comply
•
with relevant IEC Standard(e.g., IEC60950 for IT equipment and IEC60601-1 series for medical electrical
equipment). In addition, all such combination-system-shall comply with the standard IEC60601-1 and/or
IEC60601-1-1 harmonized national standard or the combination. If in doubt, contact qualified technician
or your local representative.
28
DANGER
Warning
참 조 주 의
❻ ❷
❶
❼
, or .
❷, ❸ ❹
, or .
❷, ❸ ❹
, or .
❷, ❸ ❹
❺ ❸ ❹