Waeco MAGIC WATCH MWE-150-2DIS Instructions De Montage Et De Service página 38

MWE-150-2DIS.book Seite 38 Mittwoch, 29. Juni 2005 5:20 17
All manuals and user guides at all-guides.com
Installing MAGIC WATCH
The sensor is preset to have a vertical installation angle of
approximately +5°. This means that the cover ring is thicker at the bot-
tom.
Note that the sensors must be aligned in a particular direction. The top of
the sensor is marked with a ▼ (see fig. 11.1, page 6).
The sensors may be painted but not with a multiple-coat paint as this
impairs their functionality.
The assembly procedure is as follows:
➤ Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (see fig. 11, page 6).
The plugs must be connected with the correct polarity. A blocking pin pre-
vents reverse polarity (see fig. 12 A, page 6).
Make sure the locking pin catches (see fig. 12 A, page 6). Only then is
trouble-free operation guaranteed.
To release the connection press the holder and pull the plug and socket
apart (see fig. 12 B, page 6).
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCD-1) as accessories.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ For each sensor, drill a hole with a diameter of 22 mm in the bumper.
➤ For a more accurate fit, slant the drill downwards slightly when drilling the
hole on the inside of the bumper. The sensor cover can now be easily
inserted at a downward angle.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into the corresponding drill hole until it latches into
place.
38
magic watch