Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 41

Collected_RV-HD-Compact_Q4
The camera cable must be installed in such a way that you can easily reach the plug
connection between camera and connection cable when possibly removing the camera.
The disassembly is thereby substantially simplified.
The safest type of attachment is provided through screws being put through the
construction, whereby some points are to be considered:
1. Is there enough free space for the assembly behind the selected position?
2. Each breakthrough must be protected by appropriate measures against an inrush of
underground water (e.g. by inserting the screws with sealing compound and/or
washing off the external mounting brackets with sealing compound).
3. Does the construction at the attachment place offer sufficient firmness so that the
camera holder can be tightened firmly enough?
If you are not quite sure about the assembly place selected by you, inquire with the
construction's manufacturer or its agency.
Hold the camera holder at the selected assembly place and mark at least 2 different
drilling points (see G 6).
When fastening with sheet-metal screws
The fastening with sheet metal screws may only be made on sheet steel with a
minimum thickness of 1.5 mm.
The following is to be considered when executing drill holes in the metal plate.
– Check before whether sufficient free space for the drill outlet is present.
– In order to prevent a running of the drill, prick punch with hammer and prick punch.
– Debur all drill holes and provide with rust protection.
Drill a hole of Ø 4.5 mm at the points drawn beforehand.
Screw on camera holder with the metal screws 6 x 20 mm (see G 7).
Necessary parts for the attachment with sheet-metal screws see G 1 and G 2.
When attaching thread screws
The following must be observed when drilling holes:
– Make sure that there is sufficient free space for the drill outlet.
– In order to prevent a running of the drill, prick punch with hammer and
prickpunch.
– Debur all drill holes and provide with rust protection.
– Pay attention that the nuts cannot pull themselves through the construction
when tightening (use possibly larger washers or sheet metal plates).
30/06/03 11:00
All manuals and user guides at all-guides.com
Assembly of the outside camera
Page 41
41