Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 35

Collected_RV-HD-Compact_Q4
Caution! When disconnecting the negative terminal of the battery, all volatile
memories of the comfort-electronics lose their stored data.
Depending on the vehicle's equipment, the following data may need to be
reprogrammed:
Radio-code · vehicle clock · time switch clock · onboard computer · seat position
Instructions on how to reset these can be found in the relevant operating instructions.
Warning! The components of the product (displays, monitors etc.) which are
inside the vehicle must be securely fixed so that they cannot come loose and
injure the vehicle's occupantsunder any circumstances
(sudden braking, traffic accident).
Pay attention when locating the components into the interior of the vehicle that
these are not assembled within the radius of an AIRBAG. Otherwise danger of
injury exists when it is being released. Parts of the attachable parts concealed
under panelling are to be fastened in such a way that they cannot become
loose and damage other parts and lines and impair vehicle functions (steering,
pedals etc.).
Always observe the safety information of the manufacturer! Some work (e.g. at
retaining systems such as AIRBAG etc.) may be executed only by trained
technical personnel!
Caution! To check the voltage in electrical cables, use only a diode test lamp
(see A 1) or a voltmeter (see A 2). Test lamps (see A3) which light up consume
too much current and the vehicle electronics may be damaged.
Caution! In order to avoid damages, pay attention that there is sufficient free
space for the drill outlet (see A 4). Every drill hole must be deburred and treated
with a rustproofing agent.
Caution! When installing the electrical connections, ensure they:
1. are not sharply bent and twisted (see A 5 a)
2. do no rub at the edges (see A 5 b)
3. are not laid through sharp-edged feed-through (see A 5 c).
The camera RV-26 used in this reverse video system is watertight, according to IP69K.
The sealings of the camera, however, do not withstand a high-pressure cleaner (see A 6).
However, a distance between the nozzle of the high-pressure cleaner and the camera of
approx. 50 cm should not be undercut.
30/06/03
All manuals and user guides at all-guides.com
General safety and installation instructions
11:00 Page 35
35