Cable Installation - Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio

Collected_RV-HD-Compact_Q4
Drill a hole of Ø 6.5 mm at the points drawn beforehand.
Screw on camera holder with the thread screws M 6 x 20 mm, or longer thread screws
depending upon construction strength.
Necessary parts for the attachment with sheet-metal screws see G 4 and G 5.
Execution of the breakthrough for the connecting cable of the camera
Observe the information on the cable-laying.
Use for the feed-throughof the connecting cable, according to possibility,
existing feed-through possibilities, such as e.g. ventilation grids (pay attention
to sharp edges) If no feed-through are available, then a hole must be drilled
with Ø 20 mm. Check before whether sufficient free space for the drill outlet is
present.
Drill a hole of Ø 20 mm nearby the camera (see G 9).
Debur all drill holes which are made in the sheet metal and provide with rust
protection.
Provide all sharp-edged openings with a suitable bushing.
Attachment of the camera in the camera holder
Use only the screws M 4 x 10 mm for the assembly of the camera.
Insert the camera into the camera holder. Push the camera protection over the camera
holder. Align camera in such a way that the objective shows downwards in the
direction of the road.
Fasten the camera loosely with the screws M 4 x 10 mm. The screws are tightened as
soon as the alignment of the camera has taken place by means of the monitor.
In order to minimize the corrosion of the screws, it is recommendable to grease the tap
holes.
Necessary parts for the attachment of the camera see G 10 to G 12.
General information on the cable laying!
Unprofessional cable-laying and cable connections cause again and again
malfunctions or damage of components.
A proper cable-laying or cable connection is the basic prerequisite for a
continuous and faultless functioning of the retrofitted components.
30/06/03 11:00
All manuals and user guides at all-guides.com
Assembly of the outside camera
Laying the cables
Page 42
42