Operation - Kärcher HD 13/35-4 Cage Manual De Instrucciones

Dearating the appliance
Open the water supply.
Unscrew the nozzle.
Press the lever on the hand spray gun.
Switch on the appliance and let it run
until the water exiting from the spray
pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.

Operation

Danger
The appliance may not be used in areas
–
where a risk of explosion is present.
Place the appliance on firm, even surface.
–
The high pressure cleaner must not be
–
used by children. (Risk of accident on ac-
count of improper use of the appliance).
The water jet coming out of the high
–
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence hold
the spray pipe and gun firmly.
Never direct the water jet on to persons,
–
animals, the appliance itself or electrical
components.
Risk of injury on account of high pres-
–
sure water jet and mobilised dust. Wear
protective glasses, protective gloves, a
protective suit, special safety boots and
a middle foot protection.
The jet must not be directed by the user
–
at him/herself or at other persons to
clean clothing or footwear.
Do not use the appliance while other
–
people are present.
Risk of hearing impairment. Always use
–
proper ear-protection aids while work-
ing with the appliance.
Vehicle tyres/ tyre valves may not be
–
cleaned with this appliance due the high
water pressure.
Do not spray materials contains asbes-
–
tos or other health-hazardous sub-
stances.
Pay attention to ensure that all screws
–
of all connecting hoses are tightened
properly.
The lever of the hand spray gun must
–
not be locked during the operation.
Do not drive over the main cable or the
–
high pressure hose.
Work only with adequate lighting.
–
Turning on the Appliance
Open the water supply.
Plug in the main plug.
Set the appliance switch to "I".
Unlock the safety lock at the hand-
spray gun by pressing it.
Press the lever on the hand spray gun.
High pressure operation
Warning
The handgun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing. Hold the
handgun and spray lance firmly.
Power nozzle
The appliance is equipped with the follow-
ing nozzles:
Power nozzle, 15° spray angle
High pressure flat spray (15°) for large
–
dirt areas
Note
To prevent damage due to too much pres-
sure, always position high pressure ray first
from a greater distance towards object to
be cleaned.
Set working pressure and flow rate
Pull the lever on the handgun.
Set the working pressure and quantity
by turning the pressure/ quantity regula-
tion mechanism at the pump unit.
The working pressure can be read from
the manometer.
– 5
EN 19