Appliance Is Not Running; Device Is Not Building Up Pressure - Kärcher HD 13/35-4 Cage Manual De Instrucciones

Check high pressure hose, hose con-
nections and hand spray gun for leaks.
2x blinking red:
Engine overload/overheat
–
Set the appliance switch to "0".
Allow device to cool down.
Set the appliance switch to "I".
Water pressure is too low
–
Ensure adequate water line pressure.
3x blinking red:
Fault in the voltage supply
–
Check main connections and mains
fuse.
4x blinking red:
Power consumption is too high
–
Call Customer Service.

Appliance is not running

No power
–
Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the socket.
Check the mains connection cable for
damages.
Indicator lamp is blinking green
–
Operational readiness period has ex-
pired. Switch on/off the appliance
again.
The water shortage fuse (option) was
–
triggered due to low water inlet pres-
sure.
The indicator lamp "lack of water" will il-
luminate.
Check water inlet pressure, minimum
value see "Specifications".
Turn the device switch to "0" and turn
on again to restart the system.
Motor overloaded/ over-heated or elec-
–
trical circuit breaker or winding protec-
tion switch has got released.
Switch off appliance and let it cool
down. Remove the cause of the prob-
lem. Turn on the appliance again.
22

Device is not building up pressure

Wrong nozzle
–
Check nozzle for correct size (see tech-
nical specifications).
Flushed the nozzle.
–
Clean/ replace nozzle.
Filter is dirty.
–
Clean filter at the water connection.
Unscrew the filter casing, remove the
filter, clean it and replace it.
Air within the system
–
Appliance ventilation:
Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
Pipe inlets to pump are leaky or blocked
–
Check all supply lines to the pump for
leaks or blockages.
High pressure side is leaky
3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
High pressure pump is vibrating
Check all supply lines to the high-pres-
sure pump for leaks or blockages.
Appliance ventilation:
Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
– 8
EN