Commissioning And Operation; Before Commissioning - Kärcher K 4.96 M Manual De Instrucciones

Commissioning and operation

Definition of abbreviations used:
HP = High pressure
DT = Detergent
Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the pakkage contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
The accessories, high pressure hose and
gun are included in the delivery and stored
within the appliance. The appliance comes
fully mounted, only the bearing wheels, the
handgun and the coupling element for the
water connection need to be assembled.
Illustrations on Page 2
1 Connection for water supply with filter
2 Coupling element for water connection
3 Power cord with plug
4 Storage, power cord
5 ON/OFF switch for appliance
6 Transport handle, retractable
7 Transport handle lock
8 Internal cover
9 Accessory mount
10 DT tank
11 DT suction hose with filter
12 DT metering regulator
13 HP hose
14 Handgun with safety catch
15 HP hose clip
16 Bearing wheel
17 Carrying handle
18 Spray lance with Variopower nozzle
19 Spray lance with dirt blaster
20 Washing brush*
* Special accessories (not included in deliv-
ery)
12
English
All manuals and user guides at all-guides.com
" Remove the coupling element from the
" Remove both bearing wheels from the
" Insert the bearing wheels into the axle
" Mount HP hose clip to HP hose.
" Push out the safety clip in the handgun
" Join HP hose and handgun together.
" Push clip in until it engages and check
Water supply from mains
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
" Use a fibre-reinforced hose (not includ-
" Screw the coupling unit (supplied) to the
" Push the water supply hose onto the
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the HP pump.
If the water supply is not clean, the Kärcher
water filter must be used (special accessory
- order No. 4.730-059).

Before Commissioning

lower packaging unit and mount it.
lower packaging units.
box and lock them.
using e.g. a small screwdriver.
that it is securely fastened by pulling on
the HP hose.
Water supply
ed) with a standard coupling: - Minimum
diameter, 1/2 inches (13 mm). - Mini-
mum length, 7.5 m.
water connection on the appliance.
coupling unit, then connect it to the tap.
Caution