Adjusting The Cutting Height - Worx WG789 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

horizontal position.
4) Release the safety guard to lock the grass
bag into position. Lift the handle slightly to
ensure the grass bag is installed securely.
rEmoviNg/EmPTyiNg
Lift the safety guard and hold it up. The grass
bag will drop automatically.

6. adjUSTiNg ThE CUTTiNg hEighT

(See h)
warNiNg! Stop, release safety bail and
wait until the motor stops before
adjusting height. The blade will continue to
rotate after the machine is switched off, a
rotating blade can cause injury.
CaUTioN: do not touch rotating blade.
For the first cutting of the season, a high
cutting adjustment should be selected.
The lawnmower can be set to 6 cutting heights
between 1.5" (38mm) and 3.5" (88mm)..
For this purpose, move the cutting height
adjustment lever outwards then choose the
preferred position. Each position will raise or
lower the mower to the desired height.
OPERATION
1. STarTiNg aNd SToPPiNg (See i1, i2)
warNiNg! The blade will continue
to rotate for a few seconds after the
machine is switched off. Allow the motor/blade
to stop rotating before switching "on" again.
Do not rapidly switch off and on.
STarTiNg:
warNiNg! The battery is disconnected
from your lawn mower and you must
insert the connector into the battery socket
before use.
Cordless self-propelled lawn mower
1) Insert safety key into the housing of the
switch box.
2) Push the safety key until it is fully seated
inside the housing.
3) Press down and hold the safety key,
squeeze the safety bail towards the handle
and the mower will start.
SToPPiNg
Release the safety bail. Mower will
automatically turn OFF .
2. baTTEry STaTUS lEd'S (See j)
NoTE: battery Status lEd's are
not active in charging mode. The
Status lEd's will indicate the
battery condition when the button
on the battery is pressed.
The LED's constantly senses and displays
the battery condition as follows:
Press the button "POWERTEST" ,
the light button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
illuminated, the battery charge is depleted.
Before using your new mower for the
first time, it is recommended that the
unit be charged overnight to ensure
that the battery is fully charged.
imPorTaNT
when only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the
life and performance of your battery.
3. rEmoviNg mUlChiNg PlUg (See k1)
To remove the mulching plug (12) so
that you can bag the grass or discharge
with the optional discharge chute,
follow the steps listed below:
1) Shut the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Grasp the middle of the plug, lift and
pull out the mulching plug completely.
) are illuminated, the
) is
EN
15
15

Publicidad

Tabla de contenido
loading

Tabla de contenido