Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
O
p
e
r
a
t
i
o
n
a
l
f
a
u
l
t
s
O
p
e
r
a
t
i
o
n
a
l
f
a
u
l
t
s
Before each fault elimination:
− Switch off device.
− Wait for standstill of the device.
− Pull out mains plug.
Fault
Motor does not start
Motor hums but does not start
Shredding material is not drawn
into the shredder
Shredding material not cut cleanly. Fixed counter blade not adequately
Device starts but blocks under as
slight load and switches off via
protective motor switch.
All manuals and user guides at all-guides.com
Possible cause
No power supply
Mains cable defective
Machine overloaded/blocked and auto-
matically cuts out after 5 seconds re-
versing.
Retaining basket unlocked
(safety cut-out device of the retaining
basket has tripped)
Blade shaft blocked even after several
reversing tries.
Capacitor faulty
The cutting roller is running in reverse.
Wrong switch position
Shredding material caught in funnel
Shredding material too soft or wet
Cutting roller worn
adjusted.
Extension cable too long or cross-
section to small.
Socket too far from mains supply and
cross-section of mains cable too small.
Remedy
Check fuses
have these checked (electrician)
To restart press the infeed switch
Lock the retaining basket
1. Loosen the adjusting knob (J).
2. Press the reversing switch
Bring machine to manufacturer or authorised work-
shop for repair
Switch off device and switch over direction of rotation
selector switch.
.
Press the infeed switch
Push down with a branch and shred
Adjust fixed counter blade as described under „ad-
justing the fixed counter blade". In case of severe
wear, replace cutting roller.
Adjust fixed counter blade.
Extension cable at least 1.5 mm², maximum 25 m
long. If a longer cable is used, minimum cross-
section 2.5 mm².
.
17
Publicidad
Tabla de contenido
