Shortening The Tungsten Electrode; Connecting The Cable Assembly - Abicor Binzel ABITIG GRIP Instructivo De Servicio

4 Putting into operation
Equip the torch neck according to the following figure:
1
5
1 Torch body
2 Gas nozzle
Fig. 1 Step 1-4
NOTICE
• Instead of the electrode holder, you may also use a gas diffuser. Due to its design, it will
produce a laminar gas flow.

4.2 Shortening the tungsten electrode

The electrode type is set by EN ISO 6848. The maximum electrode length depends on the torch
type.
NOTICE
• The welding performance is affected by the selection of the tungsten electrode and by
wear. A smooth, groove-free sharpened end of the tungsten electrode has a positive effect
on the welding result.

4.3 Connecting the cable assembly

1 Plug the hose assembly connection into the power source and secure it with a connection nut.
2 Properly mount the connections for water supply/return, shielding gas and control line plug.
EN - 8
All manuals and user guides at all-guides.com
Step 1 Step 2-3
4
3 Tungsten electrodes
4 Back cap
TIG welding torch
Step 4
3 2
5 Electrode holder
BAL.0093 • 2018-09-03